NCM Prague LSW1080-14-1F Controller, Verkabelung (Schaltplan / Diagramm), Bypass-Grenze, Gas

[JayCal]

Hello, I've seen some posts on this topic but they all seem to have different controllers or solutions but none have been very clear or straight forward.

I'd like to try and get around the 25kmh limit, add a throttle and find schematics to support that.

My controller is an LSW1080-14-1F which I couldn't find anything online about this controller.

There are other similar ones, but similar ones don't work with electronics. I don't want to burn out my controller by shorting it out.

Thank you in advance for any information.
Greeting Jeff.

-------------------------
English Preferred


Hello, I have seen quite a few posts on this topic but all seem to have differnt controllers or solutions but none have een very clear or straight forward.

I would like to try to bypass the 25kmh limit, add a throttle and find wiring diagams to assist in dong that.

My controller is an LSW1080-14-1F, of which I have not found anything online on this controller.

There are other simlas but similar doesnt work with electroics. I don't want to burn out my controller by shortening it out.

Thank you in advance for any information.
Regards Jeff

 

[Hochsitzcola]

Welcome!

This Lishui FOC controllers have an imprint on the PCB. There are several board layouts, but the naming of the pins is always the same.

The throttle has to be connected to SP.
There is an open source firmware for this controllers. With this firmware you can set everything according to your wishes. But the display communication protocol, that NCM uses, is not implemented yet.
There is a project, where the display is emulated with an ESP32, but I don't don't know, if it still works with recent controllers.

regards
stancecoke